Scanfil OÜ increases productivity and resource use efficiency by replacing older SMD production lines with a newer SMD production line. The new SMD production line will increase production speed and quality rate while decreasing resource use.
Project objective and outcome:
The project “Scanfil OÜ resource efficiency investment” includes a new SMD production line that will replace two older SMD production lines. The new SMD production line will increase quality rate by 1% and production capacity by 6%. Quality rate of the current SMD production line is 97,95%. The objective of the resource efficiency project is to increase quality rate over 99%.
Due to legal restrictions, the information on this part of the website is not directed at or accessible to certain persons. We kindly ask you to review the following information and provide the following confirmation each time you wish to access this part of the website. Please note that the terms set out below may be altered or updated and therefore it is important that you review them each time you visit this website.
On 25 May 2015, Scanfil Oyj announced a cash offer to the shareholders in PartnerTech AB regarding acquisition of all the shares in PartnerTech AB (the “Offer”).
The Offer is not being made in any jurisdictions where the Offer or approval of an acceptance of the Offer cannot be made in accordance with laws and regulations in these jurisdictions or where acceptance or ap-proval of an acceptance of the Offer requires additional offer documents, registration or other measures than those required under Swedish law, except in the event of applicable exemptions.
The Offer is not being made to persons whose participation in the Offer requires that any additional offer document is prepared or registration effected or that any other measures are taken in addition to those required under Swedish law. Documentation relating to the Offer must not be mailed, sent or otherwise distributed to, into or in any country in which the distribution or offering would require any additional measures required to be taken by any law or regulation in such country or that would be in conflict with any law or regulation in such country. Any such action will not be permitted or sanctioned by Scanfil Oyj. Any attempt to accept the Offer in direct or indirect violation of the abovementioned restrictions may be disre-garded.
The Offer is not being made, directly or indirectly, in or into Australia, Hong Kong, Japan, New Zealand, South Africa or the United States or in or into any other jurisdiction in which the distribution or acceptance of the Offer would not be made in compliance with the laws of such jurisdiction or where the acceptance or approval of an acceptance of the offer requires additional offer documents, registration or other measures than those required under Swedish law (together, the "Restricted Jurisdictions") by use of mail or any other means or instrumentality (including, without limitation, facsimile transmission, electronic mail, telex, tele-phone and the Internet) of interstate or foreign commerce, or of any facility of national security exchange, of the Restricted Jurisdictions, and the Offer cannot be accepted by any such use, means, instrumentality or facility of, or from within, the Restricted Jurisdictions.
Accordingly, this website should not be accessed from, and any documentation relating to the Offer is not being and should not be sent, mailed or otherwise distributed, forwarded or sent into the Restricted Juris-dictions. The offer document, the acceptance form and any documentation related to the Offer will not be sent, and must not be sent, to shareholders with registered addresses in the Restricted Jurisdictions. Banks, brokers and other institutions holding nominee-registered shares on behalf of persons in the Restricted Jurisdictions may not forward the offer documents or any documentation related to the Offer, or otherwise make the Offer available, to such persons.
By accepting these conditions, I confirm that I have read the information, the conditions and the instructions on this website and that I accept to be bound by them and that I am not a resident of, nor located in Australia, Hong Kong, Japan, New Zealand, South Africa or the United States or any other Restricted Juris-diction.
You may refuse to accept cookies from our website and delete existing cookies by selecting the appropriate settings on your browser. If you wish to do so, please refer to your browser’s user guide to find out how to control cookies by adjusting your browser’s preferences.
Full Privacy notice for our website visitors can be found here: http://www.scanfil.com/privacy.html.